Advertisement
H1 Door (left hand side)
H2 Door (right hand side)
I
Bolt and butterfly nut
J
Top panel retainer
moulding
4.
ASSEMBLY
4.1.
BACK ASSEMBLY (Step 1)
4.1.1. Place the back panels (A1& A2) on a suitably protected
flat surface to prevent scratching.
4.1.2. Interlock the tabs into the slots on the back panels and
slide together until the two panels are fully engaged and
aligned.
4.2.
SIDE ASSEMBLY (Step 2)
4.2.1. Hold the side panels (B1 & B2) at a slight angle and fit
the tabs on the back panels into the slots of the side
panels and slide up to engage.
4.3.
CROSS MEMBER ASSEMBLY (Step 3)
4.3.1. Tie the side panels together at the bottom front edge by
attaching the cross member (C) using four bolts (I) and
four butterfly nuts as shown in the inset diagram above.
© Jack Sealey Limited
1 off
1 off
4 off
2 off
Original Language Version
K
Hinge pivot moulding
L
Locking rod recess moulding
P
Hinge pin
Q
Door stop moulding
S
Shelf stop
4.4.
BASE ASSEMBLY (Step 4)
4.4.1. Place the base (D) into position as shown above and slide
it down to the bottom until its edges make contact with the
receiving channels on the back and side panels. Using a
rubber hammer, tap the base down until it is fully engaged in
the channels.
4.5.
TOP ASSEMBLY (Step 5)
4.5.1. Take the two top panel retainer mouldings (J) and fully insert
one into each hole at the top front edge of each side panel in
the orientation shown in Step 5.
4.5.2. Take the top panel (F) and hook it's front edge over the two
retainer mouldings, then swing the panel downwards until
the top edges of the back and side panels begin to enter the
receiving channels within the top panel. Tap the top panel
down into position using a rubber hammer until the four
indents in the back panels clip into the matching holes in the
back receiving channels.
4 off
2 off
4 off
4 off
8 off
SC03
Issue 2 (ALL)
17/10/23
Advertisement
