Advertisement
SECTION 4. MAINTENANCE
4.1
REMOVING THE CHASSIS FROM THE CASE
The chassis can be removed upward after unscrewing 2 black screws
from the top and 4 each from both the right and left sides. It is unnecessary
to remove bottom screws since the bottom plate comes off along with the
chassis.
4.2
FUSE ( 10 A )
If the fuse blown, be sure to check for the cause before replacement.
Use a 10 A fuse for replacement.
4.3
150 V LINE
The stabilized 150 V line has been factory-adjusted.
However, if it
becomes out of adjustment for some reason, readjust the semi-fixed resistor
(VR 1) so that 150 V is obtained with the TS-511S in receive mode.
6
Advertisement
