Table of Contents
Advertisement
F Q]iickwash pushbutton ufj
Press this button when using programme
B for cotton or L for synthetics to
reduce the wash times. Ideal for washing
lightly soiled items quickly.
G Temperature and on/off control ©
In addition to starting and stopping the
machine, this control is used to select the
wash temperature according to the
programme which has been selected. The
programme charts show the most
appropriate temperature for each type
of wash.
In the "0" position the machine is off; in
the
position the machine is on.
Adjustable temperatures also makes it
possible for both cotton and synthetic
washes to be washed at lower
temperatures than suggested or to be
washed in cold water. For the latter, the
thermostat control should be set at "1".
Remember to press the dial in before
turning it, and to switch the machine off,
turn the dial in an anticlockwise direction.
H Programme selector dial
The selector dial is marked with letters
corresponding to those on the programme
chart. To set the machine to the correct
programme (see charts from page 16 to 19)
push the dial in and turn it clockwise until
the letter you want coincides exactly with
the red pointer at the top of the dial.
Never attempt to turn the control dial in
an anticlockwise direction.
I Pilot light «operation» %
The pilot light comes on when the
machine is set to start.
K Drain filter
This is situated behind the small flap
cover at the base of the cabinet. It must
be cleaned from time to time.
(See page 26).
J Pilot light «drying>>
The pilot light comes on when the
machine is performing a drying programme.
The wash programmes
The Energetic wash cycles (A and B) for
robust fabrics are completely automatic,
taking the clothes through washing,
rinsing, spinning and draining.
The Gentle wash cycles (H - L) are for
minimum iron, drip dray and delicate
fabrics. The machine stops after the last
rinse before the water draining and
spinning. The clothes are left suspended
in water to prevent them becoming
creased by remaining in the bottom of the
wash tub in a damp state after spinning.
To complete the cycle, turn the
Programme Selector Dial to N for water
draining followed by a short spin or P for
drain only if you are washing drip dry
articles.
When using a Jetsystem programme the
water intake for the wash is totally
variable. The machine regulates the
amount of water it uses according to the
wash load. For example the machine will
use more water for a full load of absorbent
fabric than a small load of absorbent
fabric.
13
Advertisement
Table of Contents
