1. Manuals
  2. Brands
  3. Infolock Manuals
  4. Network Hardware
  5. INSIGHT DLP SENSOR 0910S
  6. Hardware installation manual

Infolock INSIGHT DLP SENSOR 0910S Hardware Installation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSIGHT DLP SENSOR 0910S Appliance
Hardware Installation Guide

Advertisement

Table of Contents
loading

Related Manuals for Infolock INSIGHT DLP SENSOR 0910S

Summary of Contents for Infolock INSIGHT DLP SENSOR 0910S

  • Page 1 INSIGHT DLP SENSOR 0910S Appliance Hardware Installation Guide...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS Section 1 Ratings ..............Section 2 Site Preparation .

  • Page 3: Ratings

    1. RATINGS 100 - 127 VAC 200 - 240 VAC Hz: 50/60 100 - 127V ~/9.2A Max (x2) 200 - 240V ~/4.4A Max (x2) 2. SITE PREPARATION Setup location, rack and appliance precautions Elevated Operating Ambient Temperature - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient temperature.

  • Page 4: Unpacking The Appliance

    3. UNPACKING THE APPLIANCE Make sure the ship kit includes the correct mounting hardware Mounting and installation hardware NOTE: Use the hardware supplied with your Eight Phillips flat head screws specific rack if different from the hardware Two power cords supplied in this kit.

  • Page 5: 4-Post Rack Installation

    4-POST RACK INSTALLATION LOCATE THE MOUNTING HARDWARE NOTE: Use the hardware supplied with your rack if different from the hardware Step 1 supplied in this kit. Locate the two adjustable rack rail assemblies Remove the inner fixed chassis rails from each rack rail assembly. Pull each inner fixed chassis rail out as far as possible.

  • Page 6: Rail Installation On The Appliance

    5. RAIL INSTALLATION ON THE APPLIANCE Locate the fixed chassis rails that were put aside in Step 1 on page 5 Mount the inner fixed chassis rails to each side of the appliance. Slide the chassis rail key hole cut outs through the chassis standoff tabs on the side of the appliance as shown below.

  • Page 7: Rear Panel Connections

    7. REAR PANEL CONNECTIONS NOTE: Do not cable the Ethernet ports at this time. Power Supply Module #1 Fan Power Supply Module #1 Power Supply Module #1 AC Receptacle Power Supply Module #1 System Status LED Power Supply Module #1 Lock Power Supply Module #2 Power Supply Module #2 Fan Power Supply Module #2 System Status LED...
  • Page 8 7. REAR PANEL CONNECTIONS (continued) MGMT SPAN Step 1 Connect the Ethernet cables for MGMT, DLP, and SPAN NOTE: The server offers redundant, hot-swap capability. The (if required). connections to AC mains should be made in a manner appropriate Step 2 Connect any other required cables.

  • Page 9: Front Panel Operation

    8. FRONT PANEL OPERATION Press the Power Button once to power the appliance on. ront Panel Illustration See Detail Chart Seria a l Number Slot USB Ports Video Port System Status LED There is a bi-color (Green/Amber) LED on the Front Panel (shown on the left). The LED operation is defined in the following table.

  • Page 10: Bezel Installation On The Appliance

    Right Fixed Left Flexible SENSOR SENSOR Bezel T Ta a b Bezel T T a a b INSIGHT DLP A ppliance 2900 S QUINCY ST #330 ARLINGTON, VA 22206 +1 (877) 610-5625 Copyright © 2018 Infolock. All rights reserved.

Table of Contents