Sony TRINITRON PVM-14L1 Service Manual page 61

Section 7
Diagrams
Note:
* Parts marked " * " differ according to the model/destination. Refer
to the mount table for each function.
* The parts marked " #" on schematic diagrams are not mounted.
All capacitors are in uF unless otherwise noted. pF: uF 50WV or
less are not indicated except for electrolytics.
All electrolytics are in 50 V unless otherwise specified.
fu} _: fusible resistor
{Ev}: nonflammable resistor
A ___: internal component
[-_] 'panel designation and adjustment for repair
Caution when replacing chip parts
New parts must be attached after removal of the chip.
Be careful not to heat the minus side of a tantalum capacitor,
because it is easily damaged by the heat.
Reference information
RESISTOR RN : METAL FILM
RC : SOLID
FPRD : NONFLAMMABLE CARBON
FUSE : NONFLAMMABLE FUSIBLE
RS : NONFLAMMABLE METAL OXIDE
RB : NONFLAMMABLE CEMENT
RW : NONFLAMMABLE WIREWOUND
K : ADJUSTMENT RESISTOR
COIL LF-8L : MICRO INDUCTOR
CAPACITOR TA : TANTALUM
PS > STYROL
PP : POLYPROPYLENE
PT : MYLAR
MPS : METALIZED POLYESTER
MPP : METALIZED POLYPROPYLENE
ALB : BIPOLAR
ALT : HIGH TEMPERATURE
ALR : HIGH RIPPLE
PVM-1411/14L1MDE/20L1
SSM-14L1/20L1
* Unit of voltage is V (volt).
* Gy : B+line
'Cy :B-line
* > © : Signal path.
NOTE:
7-1