Advertisement
E Press the Hair Length Setting Selector (1)
and slide it to the desired setting (2) (fig. 4).
See Table 1 for settings.
Table 1. Beard Trimmer
Remaining hair length
Remaining hair length
(mm)
(in)
2mm
5/64 in
4mm
5/32 in
6mm
1/4 in
8mm
5/16 in
10mm
13/32 in
12mm
15/32 in
14mm
9/16 in
16mm
41/64 in
18mm
23/32 in
D If you are trimming for the first time, start
by using the comb at the maximum trimming
length setting (23/32 in/18mm) to prevent
accidentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Setting Selector to desired trimming
length. Selector will "click" into position at each
setting.
E Switch the Trimmer ON (fig. 5).
El To trim in the most effective way, move the
Trimmer against the direction of hair growth.
Make sure the surface of the comb always
stays in contact with the skin.
NOTE:
Sin
ll hairs
n
w in the
sams
rection.
want to try different
trimmi
directions (i.e.
upwards, downwards, or across),
Practice is best for optimum results,
D If a lot of hair has accumulated in the comb,
remove the comb and blow and/or shake the
hair out of the comb. You can also use the
cleaning brush provided to remove
hair from the comb area.
» REMEMBER: You must reset the hair length
selector back to your desired setting every time
you replace the comb on the appliance.
» The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.
Beard Trimming Without
Beard & Moustache Comb
Remove comb if you are:
» Defining hair lines
D Trimming nape of neck
» Removing single, unwanted hairs
EE Be certain the Trimmer is in the OFF
position.
E Remove the comb by pressing the Hair
Length Setting Selector (1) and slide the
comb upwards (2). Pull comb off Trimmer.
EJ Switch the Trimmer ON.
EJ Make well-controlled movements. Touch the
hair/skin lightly with the Trimmer.
Advertisement
