Siemens EX8 HVC Series Information For Use page 13

lights up.
a The function is switched on.
flexMotion
15 flexMotion
You can use this function in the flexible cooking zone
to transfer the programmed power level and cooking
time from one cooking zone to another.
15.1 flexMotion
Requirement: Move the cookware to a cooking zone
which is not switched on, which you have not yet pre-
set or on which no other cookware has been previously
placed.
fryingSensor
16 fryingSensor
This function allows you to melt, prepare sauces, sauté,
deep fry or fry while keeping the temperature under
control.
Instead of constantly adjusting the power level during
cooking, select the required target temperature once at
the start. The sensors under the glass ceramic meas-
ure the temperature of the cookware and keep this
constant throughout the entire cooking process.
This function is available on all cooking zones marked
with this symbol ⁠ .
Functions Temperature
Melting 70 - 80 ºC
Preparing sauces 110 - 120 ºC
Frying 140 ºC
Frying 160 ºC
Frying 180 - 200 ºC
Frying 220 ºC
16.1 Recommended cookware
Special cookware has been developed for this function,
which delivers the best results.
The recommended cookware is available from cus-
tomer service, specialist retailers or our online shop
siemens-home.bsh-group.com.
14.2 Switching off Keep-warm function
Select the cooking zone.
1.
Set to
2.
goes out.
a The function is switched off.
Move the cookware.
1.
a The cookware is detected.
a The previously selected power level and flash al-
ternately on the display for the new cooking zone.
Select the new cooking zone to implement the set-
2.
tings.
a The original cooking zone is set to
a The settings are transferred to the new cooking
zone.
Note: If you place a new item of cookware on a differ-
ent cooking zone before you have confirmed the set-
tings, you can use this function for the new item of
cookware.
Note: You can also use other cookware. Depending on
the composition of the cookware, the achieved temper-
ature may differ from the selected temperature level.
16.2 Switching on the fryingSensor
Place the empty cookware on a cooking zone.
1.
Select the cooking zone.
2.
Press ⁠ .
3.
a , and the preset temperature light up on the dis-
play for the selected cooking zone.
Select the temperature by swiping your finger over
4.
the settings area.
flashes until the set temperature is reached again.
a
a The selected temperature and the development of
the temperature reached in the pan flash alternately
until the selected temperature has been reached.
a The temperature shown on the displays is approxim-
ate and may differ from the actual temperature in
the frying pan.
a Once the temperature has been reached, a signal
tone sounds and as well as the temperature sym-
bol stop flashing.
5. Add the frying fat and then the food to the frying
pan.
Note: If you need to cook with more than 250 ml oil,
add the oil and wait a few seconds before you add the
food.
flexMotion en
13