Advertisement
Thermostat
The thermostat is placed in the control panel, see fig. 2.0.
The thermostat has been pre-set and in most cases it is not
necessary to adjust the settings.
When turning on the cabinet the display will show the current
temperature in the cabinet.
Display set temperature
Press this key and the display will show the set temperature. Press the key again to
SET
return to normal reading.
Set new temperature:
SET
Press this key and the display shows the set temperature.
Press this key to increase the set temperature.
Press this key to lower the set temperature.
Press this key to save the new settings. The display will flash with the new value and
SET
will then return to normal reading.
Alarm codes
PF1—Flashing in the display: indicates that the cabinet sensor is defective. The cabinet will
strive to keep the set temperature until it has been repaired.
PF2—Flashing in the display: indicates that the evaporator sensor is defective. This does not
influence the operation of the cabinet, but should be repaired as soon as possible.
DISTRIBUTED BY:
5
SOUTHERN
p: 0800 503 335 | w: www.southernhospitality.co.nz
HOSPITALITY
e: weborders@southernhospitality.co.nz
Fig 2.0
Advertisement
