Related Manuals for Hanwha Vision SHB-V-3200HPR
Summary of Contents for Hanwha Vision SHB-V-3200HPR
- Page 1 SHB-V-3200HPR Outdoor Enclosure Kit for Box Cameras Installation Manual English - Instruction manual...
- Page 2 overview WHAT’S INCLUDED Please check if your camera and accessories are all included in the product package. Each item may be package in its' own box. This document may refer to each component using the item names listed below. Appearance Item Name Quantity HOV32K2A700...
-
Page 3: Table Of Contents
Contents E N G L I S H 1 About this manual ........................3 1.1 Typographical conventions ..............................3 2 Notes on copyright and information on trademarks ............. 3 3 Safety rules..........................3 4 Identification ..........................4 4.1 Product description and type designation ........................4 4.2 Product marking .................................. -
Page 4: About This Manual
1 About this manual 3 Safety rules Read all the documentation supplied carefully CAUTION! Device installation and before installing and using this product. Keep the maintaining must be performed by manual in a convenient place for future reference. specialist technical staff only. Note: Some sections of the manual that refer to CAUTION! The electrical system to which options that are not available have been removed. -
Page 5: Identification
• This device was designed to be permanently • A power disconnect device must be included secured and connected on a building or on a in the electrical installation, and it must be very suitable structure. The device must be permanently quickly recognizable and operated if needed. -
Page 6: Preparing The Product For Use
5 Preparing the product for 5.3 Safely disposing of packaging material The packaging material can all be recycled. The Any change that is not expressly approved installer technician will be responsible for separating by the manufacturer will invalidate the the material for disposal, and in any case for guarantee. -
Page 7: Installation
6 Installation 6.3 Installation of cable glands The product may be interfaced with Inside the supply are 3 cable glands that must be devices not manufactured by Hanwha or installed at the bottom of the housing as shown VIDEOTEC. It is recommended a test prior in figure. -
Page 8: Ethernet Cable Installation
6.4.2 Ethernet cable installation Insert the Ethernet cable in the gasket and block it as shown in figure. Fig. 5 Fit the gasket (01) to the cable gland M20 (02). Fasten the cable gland to the bottom of the housing (03) using the M20 nut (04). -
Page 9: How To Install The Camera
6.4.3 How to install the camera 6.4.4 Connection of the GEKO IRH illuminator The correct operation of the equipment, Connect the illuminator to the J6 terminal as within the temperature range indicated, is described in the diagram below. guaranteed only if you use camera and lens with temperature limits equal to at least -10°C and +60°C. -
Page 10: Poe Cable Connection
6.4.5 PoE cable connection Connect the PoE cable from the Power Injector to the J1 connector. Fig. 10 Before powering the device, you must set the maximum power consumption of the housing operating on dip switch SW1 (7 Configuration, page 7 Configuration Before powering the device, you must set the maximum power consumption of the housing... -
Page 11: Switching On
HOV HI-POE IPM AVAILABLE MODELS AND FEATURES Operating Injector Camera Illuminator temperature √ From -10°C PoE class 3 PoE max. class √ (14°F) up to (13W) 2 (7W) +60°C (140°F) √ √ Hi-PoE class 4 PoE max. class (25W) 3 (13W) Tab. -
Page 12: Maintenance And Cleaning
9 Maintenance and cleaning OPERATING STATUS LED Status Apparatus Status 9.1 Maintenance LD1 (Power The device is not powered supply) The device is correctly powered 9.1.1 Kit for upgrading of the The camera is not connected or equipment (Camera) Cold Start is active The camera is correctly powered The kit cannot be installed in the housing 1 flashing... -
Page 13: Information On Disposal And Recycling
10 Information on disposal Data line: 10/100Base-T Illuminator GEKO IRH, low power: 6W and recycling Compatible with IEEE 802.3af, IEEE 802.3at/PoE Plus The European Directive 2012/19/EU on Waste Compatible with standard PoE/PoE+ Power Electrical and Electronic Equipment (WEEE) mandates Injectors, not included. that these devices should not be disposed of in the 11.4 Environment normal flow of municipal solid waste, but they should... -
Page 14: Technical Drawings
12 Technical drawings The indicated measurements are expressed in millimetres. USABLE USABLE AREA AREA A - A B - B Fig. 16 HOV HiPoE IPM. MNVCHOVHPOE_2222_EN...
Need help?
Do you have a question about the SHB-V-3200HPR and is the answer not in the manual?
Questions and answers