Zanussi MGE1255B Instructions For The Use And Care page 12

The clock
The digital 24 hour clock operates even when the oven is not in use. The clock should
always be set and running. While most timing can be done if the clock is not set, the
TIME/START feature cannot. The oven should be turned off by the switch button
before setting the clock.
To recall the time of day during cooking, simply touch the CLOCK button and the
correct time of day will appear for 3 seconds on the display window.
If no time is set, or the wrong time, (e.g. 33:00), a flashing colon appears in the display
window. If the oven is unplugged or the power is off, the time will be lost. When power
is restored, the flashing colon will appear to remind you to reset the clock. If an
incorrect time appears, touch the CLOCK button.
To set the clock to the correct time of day.
• Suppose you wish to set the clock to 1:49pm (13:49).
PROCEDURE
BUTTON ORDER
DISPLAY
1: Touch the CLOCK button
CLOCK
o
FLASHING
■
■
2: Touch the numbers 1, 3, 4 and
9 buttons
13 4 9
o o o o
PRESS Once Once Once Once
i
3: Touch the START button
Start
o
Setting the cook programmes
To cook at Full Power:
As the oven automatically cooks at High level you would normally only need to
programme the cooking times required.
• Suppose you wish to set the cooking time for 45 seconds at full power.
PROCEDURE
BUTTON ORDER
DISPLAY
1: Push in the switch button
h h
press r
00:00
1
2: Touch the numbers 4 and
5 buttons
4 S
o o
PRESS Once Once
:45
1
3: Touch the START button
Start
o
:45
1
The cooking time will count down to zero at the end of all cooking cycles. When the
timer reaches zero, the indicators will go out and you will hear four 'bleeps'. Microwave
energy will stop and the time of day will reappear on the display, after the ON/OFF
button is released.
If the door is opened during the cooking process, the cooking time in the readout
automatically stops. The cooking time starts to count down again when the door is
closed as the START button is touched.
If you have touched START and the oven is operating, you can double-check the cooking
function times you have set by touching the retrospective function button EXCEPT for
any cooking function already in operation or completed. This information will appear on
the display window for 3 seconds, then the display will go back to whatever cooking
function the oven is in. i -i