Table of Contents
Advertisement
performed by unquali ed personnel could result in risk of injury.
- When servicing a tool, use only identical replacement parts. Follow instructions in the
Maintenance section of this manual. Use of unauthorized parts or failure to follow Mainte
nance instructions may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES
- For your safety, do not plug in your Power tool until you have read and understood this
Owner's Manual.
• WEAR EYE PROTECTION. Use face or dust mask along with safety goggles. Use
hearing protection, particularly during extended periods of operation, wear safety shoes,
wear hard hat
• "Wear ear protectors with impact chisels. Exposure to noise can cause hearing loss"
• DO NOT wear gloves, jewellery, neckties or loose clothing.
• DO NOT drill, cut or sand material too small to be securely held.
• ALWAYS keep hands out of the path of the drill bit and saw blade. Avoid awkward hand
positions where a sudden slip could cause your hand to move into the path of the drill bit
or saw blade.
• SECURE WORKPIECE. Use clamps or a vice to hold the work when practical. It is safer
than using your hand and it frees both hands to operate the tool.
• MAKE SURE there are no nails or foreign objects in the part of the workpiece to be cut
drilled or sanded.
DRILL SAFETY
• TO AVOID INJURY from accidental starting, always remove the Plug from the electrical
socket before installing or removing a chisel bit.
• When using electric hammer chisel only use bits that are con gured with the correct slots
for this chuck.
• BEFORE STARTING the operation, jog the chisel switch to make sure the chisel bit does
not wobble or vibrate.
• DO NOT USE y cutters or multiple-part hole cutters, as they can come apart or become
unbalanced in use.
• MAKE SURE the spindle has come to a complete stop before touching the chuck or
attempting to change the chisel bit also beware that the bit will be hot, let it cool down
before changing as it could burn and cause injury.
• ALWAYS MAKE SURE THE CHISEL OR CHISEL IS FIRMLY SEATED IN THE Hex CHUCK
before starting the job in hand.
SYMBOLS
Some of the following symbols may be used on your tool. Please study them and learn their
meaning. Proper interpretation of these symbols will allow you to operate the tool better
and safer.
V
Volts
A
Amperes
Hz
Hertz
Kw
kilowatts
W
Watt
F
Farads
µF
Microfarads
I
Litres
8
Advertisement
Table of Contents
