Maintenance - Toro 04012 Operator's Manual

Monitoring the
Charging Process and
Troubleshooting
Note:
The LCD status display displays messages during the
course of charging. Most are routine.
If there is a fault, the error indicator light will flash amber, or light
solid red. An error message will appear in the LCD display
1) 1 digit at a time, starting with the letter E or F (for example,
E-0-1-1).
To correct an error, refer to
of these solutions correct the issue, contact an authorized Toro
distributor.
Completion of the Charging
Process
When charging is complete, the battery charging indicator light
shows solid green (Figure 1).
Disconnecting the Charger
1. Disconnect the charger T-handle connector from the main
battery power supply connector affixed to the battery tray.
Important:
Do not pull on the cables
2. Place the charger T-handle and cord in a storage position
that will avoid damage.
3. Ensure that the T-handle and battery pack connectors are
clean.
4. Connect the T-handle to the battery pack connector
3)
5. Turn on machine power (See the Operator's Manual) and
verify battery charge displayed on the InfoCenter matches
that as stated on the charger.
Troubleshooting (page 8). If none

Maintenance

Important:
an authorized Toro distributor only.
The operator can perform very little maintenance other than
protecting the charger from damage and weather.
Maintaining the Cords
(Figure
•
Clean the cords with a slightly damp cloth after each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and replace them
when necessary with Toro-approved parts.
Cleaning the Case
Clean the case with a slightly damp cloth after each use.
Service
This charger is a solid-state device and should not require service
under normal operating conditions and use according to these
instructions. Should it need service, bring the charger to an
authorized Toro distributor. Repair by service centers not operated
by Toro may result in damage to connected equipment and is
not covered under the warranty.
Storage
(Figure 1. Complete the procedure for
(page 7).
2. Disconnect the power supply cord from the charger and coil
it securely.
3. Examine the power supply cord thoroughly for signs of wear
or damage. Replace it if it is worn or damaged.
4. Examine the charger thoroughly for worn, loose, or damaged
parts. To repair or replace parts, contact your authorized
Toro distributor for assistance.
5. Store the charger with the power supply cord in a clean,
dry place where it will not be bumped or damaged and not
exposed to caustic fumes.
7
All electrical repairs should be performed by
Disconnecting the Charger