Connecting To A Power Source; Charging The Battery - Toro 04012 Operator's Manual

Lithium battery charger and greensmaster eflex traction units
Table of Contents

Advertisement

Connecting to a Power
Source
To reduce the risk of electric shock, this charger has a 3-prong
grounded plug (type B). If the plug does not fit into the wall
receptacle, other grounded plug types are available; contact an
authorized Toro distributor.
Do not change the charger or the power supply cord plug in any
way.
DANGER
Contact with water while operating the machine could
cause electric shock, causing injury or death.
Do not handle the plug or the charger with wet hands
or while standing in water.
Important:
Check the power supply cord periodically for
holes or cracks in the insulation. Do not use a damaged cord.
Do not run the cord through standing water or wet grass.
1.
Insert the charger plug on the power supply cord into the
matching input power socket on the charger.
WARNING
A damaged charger cord can cause an electrical
shock or a fire.
Thoroughly inspect the power supply cord before
using the charger. If the cord is damaged, do not
operate the charger until you obtain a replacement.
2.
Insert the wall plug end of the power supply cord into a
grounded electrical outlet.

Charging the Battery

CAUTION
Attempting to charge batteries other than the Toro
Model 04049 or the 04069 lithium-ion battery pack
with this charger can result in excessive heat and
other related product malfunctions, which can lead to
property damage and/or injury.
Do not attempt to charge batteries other than those
that are compatible with this charger.
DANGER
Battery charging is dangerous when done improperly.
Do not allow untrained people to operate this
equipment.
Thoroughly review the safety instructions at
the start of this manual before you operate this
equipment.
Keep this manual with the charger at all times.
Recommended charging
range
Low-temperature charging
range (Reduced Current)
High-temperature charging
range (Reduced Current)
1.
Park the machine in the location designated for overnight
charging.
2.
Set the parking brake
5
0° to 45°C (32° to 113°F)
-10° to 0°C (14° to 32°F)
45° to 60°C (113° to 140°F)
(Figure
2).

Advertisement

Table of Contents
loading

This manual is also suitable for:

0409004065

Table of Contents