Beko BHCB67841BBHSI User Manual page 16

If you run your hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, your hood warns
again.
Carbon filter fill warning (for products with
carbon filter)
The light of key flashes after every 100
hours of operation. In this case, you must
replace your carbon filter. Consult an au-
thorized service for this. After replacement,
the lamp warning of
off automatically. When you touch the
key for more than 3 seconds, carbon filter
fill warning is reset and the lamp is turned
off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of
ing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again.
If you turn off the warning without
replacing the carbon filter, the oper-
ating time of 100 hours is reset and
it starts over. At the end of the next
100 hours, warning is given again.
key does not turn
key flash-
EN / 16
Using the HomeWhiz application
Follow the steps described below to control
and monitor your hood via a smart device.
You shall connect your tablet to your home
network, and download the HomeWhiz ap-
plication to your smart device from the app
store of your smart device.
1. Open the application downloaded via
your smart device.
2. Press "add/remove product" section on
the smart device.
3. Perform the installation by following the
instructions provided on the smart
device.
4. Keep the function key pressed for about
5 seconds. The " " symbol shall flash
on the display.
5. Connect to your hood with the user
name and password given on the app
from the settings section of your smart
device.
6. Select the network you are using from
the network list and connect your hood
to the network with the required pass-
word. The " " symbol shall be displayed
continuously when the installation is
complete. You may enter your app and
start to use your hood by naming it from
the "add/remove product" section.
If it is not possible to establish a
network connection within 5
minutes after pressing the function
key for about 5 seconds, the install-
ation of homewhiz application shall
be ended and the " " symbol shall
be turned off.
Way of usage:
Touch key once to control your product
via a smart device. The " " symbol flashes
on the display. In the meantime, connection
with smart devices is searched. When the
connection is made, the symbol " " will
constantly light up.
EN
RO
FR