PASCO PS-3599 Instruction Sheet

Wireless Sensor Charging Station

Introduction

The PS-3599 Wireless Sensor Charging Station provides
an organized way to charge all types of PASCO wireless
sensors. Up to ten PASCO wireless sensors can be
charged simultaneously. The charging station can be
configured to fit any size sensor by adding or removing
the included dividers.

Operation

Installing a plug into the power supply

After unboxing the Wireless Sensor Charging Station for
the first time, insert the plug corresponding to your
electrical receptacle into the power supply (Figure 1).
Figure 1: Insert a plug into the power supply.
800-772-8700
PS-3599

How to charge PASCO wireless sensors

1. Connect the power supply to the power input jack
on the charging station (Figure 2).
2. Connect the power supply to an electrical
receptacle outlet.
3. Connect a USB cable to any USB A port on the
charging station (Figure 2) then connect the other
end of the cable to a sensor.
4. Place the sensor into the charging station and
insert a divider to create a partition (Figure 3).
5. Repeat steps 3 and 4 for up to nine additional
wireless sensors.
Figure 2: Rear View of the Wireless Sensor Charging Station
Instruction Sheet
012-16144A
www.pasco.com