Operation And Maintenance - Booster ES2500EU Manual

as a result. When not in use, leave your jump starter connected to the wall charger or
recharge every three (3) months.
The appliance can be used by persons aged from 16 years and above and persons
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, if they have been given supervision or instruction in use of the appliance
in a safe way and understand the hazards involved. Children should be supervised to
insure that they do not play with the appliance.

OPERATION AND MAINTENANCE

Portable Power Source Features
The jump starter provides plenty of power for starting vehicles – more than enough to
start most cars, vans, SUVs, light trucks and delivery vehicles.
The jump starter will power most 12VDC accessories equipped with a male 12 Volt
outlet plug. The DC outlet features automatic overload protection.
The unit features a test switch and LED lights. State of the art circuitry allows the unit
to remain continuously connected to the charger without the risk of overcharging.
Safety Features
Safety storage holsters prevent accidental sparking of clamps and rotate 90° for easy
clamp removal and replacement. Always re-wrap cables and properly secure clamps in
holsters after each use.
The jump starter contains the latest technology with its 12 Volt sealed, non-spillable
battery and may be stored in any position.
Recharging Procedures
Note: Upon initial purchase or after long periods of inactivity, your jump starter should
be charged for a minimum of 24 hours.
Note: During charging, the unit must be placed in a well ventilated area.
Test Button, Charging, Power Levels and Charge Complete LEDs
There are two ways to charge your jump starter. The recommended method is
automatic charging using the supplied wall charger. An alternative method is through
the DC power outlet using the provided 12 Volt Male-Male Extension Cord. This
second method is not automatic and must be monitored because the jump starter
could be damaged due to overcharging, plus the Voltage Selector Switch must be in
the 12V position when using this charging method.
Charging using the supplied wall charger (recommended method). This is the
recommended charging method because it features automatic charging, eliminating
4