Table of Contents
Advertisement
Advanced
Functions
|
C.RESET
recordings. Remember to install the backup battery
characters.
scene. Press the button again to cancel the
display.
* If you choose the flashing dot =, nothing will
be recorded at this position.
button.
These lines appear in the
viewfinder while you are writing a
5. When the character you want is
title.
displayed, press the < or > side of the
FlexiZone controller to move the cursor
to the point where you want to write the
Enter your title in the camera's memory before you
next character.
start recording. The title can be one or two lines of
up to 16 characters each.
6. Repeat steps 4 and 5 until your title is
complete, then press the TITLE button
1. Set the OPERATE switch to CAMERA.
to enter the title in the memory.
2. Press and hold the TITLE button until
the title lines appear in the viewfinder.
* If you have already entered a title in the
memory, it will be displayed in the viewfinder.
* The first dot (or character) flashes to show
where the cursor (the insertion point) is
located.
3. Press the 4 or » side of the FlexiZone
controller to move the cursor to the
point where you want to start the title.
* Press once to move the cursor one space at a
Note:
time. Press and hold to move it quickly.
if it takes you more than about five minutes to
write a title, the camera may turn itself off
automatically before you finish. This can be
avoided by removing the cassette before you
begin.
Advertisement
Table of Contents
