Table of Contents
Advertisement
MOWING
STARTING THE MOWER
Hl^ NOTE
In heavy grass, full throttle may be needed
when starting the mowing deck.
With the engine running at idle speed, start the power
take-off clutch (see page 15, Figure 15). Starting the
mower with the engine in idle will reduce wear on the
drive belt. Increase engine speed to full throttle.
Mowing should be done with the engine at full throttle.
Do not mow at high ground speed.
During certain times of the year and under some con¬
ditions, the mower may leave streaks of uncut
material.
Streaking may occur when attempting to mow heavy
weeds and tall grass. Under these conditions it may
be necessary to go back over the cut area a second
time to get a clean cut.
STOPPING THE MOWER
Move the power take-off (PTO) switch to "OFF" and
reduce engine speed.
The following practices will help eliminate streaking:
1. Mow the area more often so the grass doesn't get
too tall and heavy.
MOWING
WARNING
To avoid possible injury, do not allow anyone
in the area opposite the discharge chute
while mowing. Although the area has been
supposedly cleared of foreign objects, small
objects may be discharged by the mower.
A
WARNING
Never direct discharge of material toward
bystanders
or
allow
anyone
near the
machine while in operation.
For best results it is recommended that the first two
laps should be cut with the discharge thrown towards
the center. After the first two laps, reverse the direc¬
tion to throw the discharge to the outside for the bal¬
ance of cutting. This will give a better appearance to
the lawn.
Do not cut the grass too short, as the mower will tend
to scalp the grass. Short grass invites weed growth
and yellows quickly in dry weather.
2.
Operate the tractor at full throttle and lower for¬
ward speeds.
3.
Keep the blades sharp and replace blades when
worn.
4.
Follow the mowing procedure shown in Figure 29.
Figure 29
26
Advertisement
Table of Contents
