Onkyo TX-8210 Instruction Manual page 15

Receiving stations
If you tune in a stereo FM station, the STEREO display will be illumi-
nated if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune into your desired sta-
tion. In this case, tune in as follows.
Press the FM MUTE/MODE button and FM MUTE "OFF" lights. At
this time, the station will be in mono and interstation noise will be heard.
Select the station you want to listen to.
MEMORY FM MUTE-MODE
\_ CLEAR
This unit is equipped with an APR system to help tune in FM stations.
When receiving an FM station using manual or direct tuning, RF
MODE LOCAL/DX and STEREO MODE AUTO/MONO settings are
RF STEREO
made automatically, according to the station being received.
APR
MODE MODE
Be Ee
The APR system automatically sets the gain of the RF section to DX or
LOCAL according to the quality of the signal being received. The RF
MODE will indicate LOCAL when sufficient signal is received.
If the MONO indicator lights up while a station is tuned in, the station
will be received in mono even if it is a stereo station.
The STEREO MODE AUTO/MONO settings that the APR system
makes can be changed by pressing the FM MUTE/MODE button.
Since ten AM ar FM stations can be stored
in each group (A, B or C), a total of 30 sta-
tions can be stored in the memory.
Programming radio station
1. Select the frequency that you want to
store in the memory.
(See page 14 Tuning the radio)
2. Press the MEMORY button.
The MEMORY indicator will light for
= ieee au Sree" 8 seconds.
"ODE MOCE
7 .
Lt pe | . 3. While the MEMORY _ indicator
lights, press the GROUP button to
choose the desired group.
The group shown on the display
changes in the following order each
a Co >A.
— CLEAR PEI 4. Select the desired memory number
using the number buttons.
Press button 0/10 when choosing mem-
ory number 10.
EM MUG RTLAEC iy
on S7EREO MEMGHY
ia ay
NOTE (TX-8210R):
If the FM station received is an RDS sta-
tion with a PS (Program Service Name),
the frequency display will change to the PS
display. If there is no PS, the frequency
display will not change.
(Refer to page 18 — 19 for the RDS func-
ion
FM MUTE TUNED @
Para rary
*
o
15