Adjusting Wire Brush; Adjusting Saw Arm - Sharp SW-180NC Instruction Manual

ADJUSTING WIRE BRUSH

Follow these steps to adjust wire brush to appropriate position:
Step 1 - Loosen the lock lever and the wire brush cover.
Step 2 - Adjust the screw to make brush move up / down until it makes proper contact with the saw
blade (see below illustration).
Step 3 - Reinstall the wire brush cover

ADJUSTING SAW ARM

Adjust the blade guide (guide arm) position based on the size of your workpiece:
Step 1 – Loosen the inserts by unlocking the lock bar.
Step 2 – Loosen the blade guide locking handle. Then adjust the guide arm to a position suitable for
your workpiece size.
Step 3 – After adjustment is made, tighten the blade guide locking handle.
Step 4 – Clamp the inserts back by locking the lock bar.
and tighten the lock lever.
Screws
Lock Lever
Blade Guide Locking Handle
Inserts Lock Bar
Proper Improper
4-27