EXC ECOLOR EC-S5050 Manual

Smd led strip

Advertisement

Quick Links

EC-S5050 SMD LED strip
Application Environment:
Indoor
Outdoor

Basic Specifications

Color
Working Voltage
Max. Power Consumption
Light Source
Length
Min shearable length
Control
Source Life
Light efficiency
RGB
DC24V
9W/1M
60pcs
LEDs/1M
5m/roll
100mm
DMX512
50,000h
30LM / W

Description

LED strip lights for indoor or outdoor applications,
such as under-cabinet lighting, coves,
landscapes, vehicles, and more. Choose 24V or
12V LED tape lights of any color, brightness, or
length, and install them using a range of
compatible accessories

Features

10 m long cascading CSP bare led strip with
low voltage
drop;
Small size, thin and light, with small bending
force
point;
Large luminous Angle, up to 160°, light color
clean and soft, no yellow edge, good
consistency;
Simple structure, low thermal resistance, long
life, high
reliability;
Application scenarios: Indoor Spaces:
background layout, interior decoration lighting,
advertising decoration,
etc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECOLOR EC-S5050 and is the answer not in the manual?

Questions and answers

Summary of Contents for EXC ECOLOR EC-S5050

  • Page 1 EC-S5050 SMD LED strip Description LED strip lights for indoor or outdoor applications, such as under-cabinet lighting, coves, landscapes, vehicles, and more. Choose 24V or 12V LED tape lights of any color, brightness, or length, and install them using a range of compatible accessories Features ●...
  • Page 2 Dimensions Working Temperature -30°C to 50°C Storage Temperature -40°C to 70°C Packaging Information Remark: The above-mentioned packaging quantity and weight are only for the illustrated packaging method. For other packaging methods, the packaging quantity and weight will be different. Specific to the actual product. Packaging diagram Installation electrical connection diagram...
  • Page 3 1. 5m CSP bare light strip, there is a pad every 100 mm of the light strip, the best position to cut the light strip is in the middle of the pad, otherwise it will cause waste; 2. There is a 3M double-sided tape on the back of the light strip. Before use, tear off the sticker and paste it to the installation position and compact it before use.
  • Page 4 The lamp strip at the corner is After the lamp belt is installed, the The place where the scissor mouth of installed as shown in the figure lamp belt wire is connected to the the lamp belt contacts the bottom of above, please note: power output end.

This manual is also suitable for:

300889

Table of Contents