LG SKSFD3613 Series Owner's Manual page 52

us_main.book.book Page 52 Wednesday, September 23, 2020 1:25 PM
52 TROUBLESHOOTING
Craft Ice
Problem
Icemaker is not Refrigerator was recently installed or icemaker recently connected.
making ice.
• The icemaker begins producing ice approximately 48 hours after the appliance is initially
Icemaker is not In 3 ICE mode (default setting), the Craft Ice icemaker produces 1 batch of round ice
making enough ice. about every 24 hours.
• For more ice, select the 6 ICE mode.
Ice
Problem
Icemaker is not Demand exceeds ice production capacity.
making enough ice.
• Refer to the Automatic Icemaker section for ice production capacity to check the amount
House water supply is not connected, valve is not turned on fully, or valve is clogged.
• Connect the refrigerator to a cold water supply with adequate pressure and turn the water
Water filter has been exhausted.
• Replacing the water filter is recommended:
Low house water supply pressure.
• The water pressure must be between 20 and 120 psi (138 and 827 kPa) on models without
Reverse osmosis filtration system is used.
• Reverse osmosis filtration systems can reduce the water pressure below the minimum
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning
Doors are opened often or for long periods of time.
• If the doors of the unit are opened often, ambient air will warm the refrigerator which will
Doors are not closed completely.
• If the doors are not properly closed, ice production will be affected. See the "Doors will not
The temperature setting for the freezer is too warm.
• The recommended temperature for the freezer compartment for normal ice production is
installed. The first batches of ice may not be round and clear.
of ice produced in a 24 hour period.
shutoff valve fully open. If the problem persists, it may be necessary to contact a plumber.
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
a water filter and between 40 and 120 psi (276 and 827 kPa) on models with a water filter.
If the problem persists, it may be necessary to contact a plumber.
amount and result in icemaker issues. (Refer to the Connecting the Water Line section.)
resulting in reduced water flow. Straighten or repair the water supply line and arrange it to
prevent future kinks.
prevent the unit from maintaining the set temperature. Lowering the refrigerator
temperature can help, as well as not opening the doors as frequently.
close correctly or pop open" section in Parts & Features Troubleshooting for more
information.
0 °F (-18 °C). If the freezer temperature is warmer, ice production will be affected.
Possible Cause & Solution
Possible Cause & Solution