Advertisement
Quick Links
Products Warranty – Australia
For warranty details see our website:
https://www.faucetstrommen.com.au/warranty/
Installation Guide
Cabinet Bar Pull
Suits Models:
36015 36016 36017 36018 36019 36020 36021 36022 36023 36024 36025 36026
36027 36028 36029 36030 36031 36032 36033 36034 36035 36036 36037 36038
36039
Important requirements:
This product is designed to be installed onto cabinet door and drawer fronts. 40mm
screws have been supplied for regular front thicknesses, refer drawing below for details.
Cleaning
Clean only with a soft microfiber or similar cloth and warm clean water. Ensure that
the cloth is clean and free of any grit or chemical. Dry fitting off with a soft clean cloth.
Ensure that your fitting is not subject to any chemicals, building grit or any type of
abrasive of polish. For care of special finishes please visit our website.
Front thickness 15 ~ 25
64 / 96 / 128 / 160 / 320
10
144 / 176 / 208 / 240 / 400
Front thickness 15 ~ 25
64 / 96 / 128 / 160 / 320
10
144 / 176 / 208 / 240 / 400
Front thickness 15 ~ 25
64 / 96 / 128 / 160 / 320
10
144 / 176 / 208 / 240 / 400
Faucet Australia Pty Ltd
ABN 83683523321
www.faucetstrommen.com.au
P: +61 3 5450 4236
Release Date: 13.12.23
28
Front thickness 15 ~ 25
96 / 128 / 160 / 192 / 352
11
126 / 158 / 190 / 222 / 382
28
Front thickness 15 ~ 25
96 / 128 / 160 / 192 / 352
11
126 / 158 / 190 / 222 / 382
28
31 Tate Drive, Kerang VIC 3579
sales@faucetstrommen.com.au
IG 042
Advertisement
Related Manuals for faucet strommen 36015
Summary of Contents for faucet strommen 36015
- Page 1 Installation Guide Cabinet Bar Pull Suits Models: 36015 36016 36017 36018 36019 36020 36021 36022 36023 36024 36025 36026 36027 36028 36029 36030 36031 36032 36033 36034 36035 36036 36037 36038 36039 Important requirements: This product is designed to be installed onto cabinet door and drawer fronts. 40mm screws have been supplied for regular front thicknesses, refer drawing below for details.
- Page 2 Installation Measure and Mark: Determine the ideal placement for the bar pull on your door or drawer. Use a measuring tape to find the center points of the fixing points, then mark a cross with a pencil. Hold the cabinet pull against the door or drawer front to confirm positions. 64 / 96 / 128 / 160 / 192 / 320 /352 (check specific model) Pre-Drill Holes: Use a 4.5 mm drill bit to pre-drill holes at the marked locations.