How To Connect The Pc Input Terminals - Panasonic PT-52DL10 Operating Instructions Manual

Installation
How to connect the PC Input Terminals
COMPUTER
[_ _QQ/PC INPUT INPUT 4
Conversion adapter (if necessary)
PC cable
(supplied)
\\\
TSXF147 (1.5 m)
_k _.ZD - Audio
!
Connect a cable which matches
D-SUB 15P
2 x RCA plug
the audio output terminal on the computer.
Signal Names for D-SUB 15P Connector
Pin Layout for PC Input
Terminal
Pin No.
Q
®
®
®
®
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Pin No.
®
®
®
®
®
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Pin No.
©
@
@
@
@
Signal Name
GND (Ground)
SDA
HD / SYNC
VD
SCL
Notes:
(1) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will
need to make setting changes at the computer at the time of connection.
(2) Some PC models cannot be connected to the set.
(3) An adapter is required to use the PC cable (D-SUB 15P) to connect a Macintosh computer to the set.
(4) There is no need to use an adapter for computers with PC / AT compatible D-SUB 15P terminal.
(5) The computer shown in the illustration is for example purposes only.
(6) Additional equipment and cables shown are not supplied with this set.
(7) The picture will become dark if a PC signal with a vertical scanning frequency of 62 Hz is input. To obtain the optimum
picture quality with the projection TV, a vertical scanning frequency of 60 Hz is recommended.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
14