Samsung WW90J5 Series User Manual page 45

Problem
Stops.
Fills with the wrong
water temperature.
Load is wet at the
end of a cycle.
WW80J5260GS_03504L-05_EN(PL).indd 45
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press or tap Start/Pause to start the
washing machine.
For your safety, the washing machine will not tumble or spin
unless the door is closed.
• Before the washing machine starts to fill, it will make a series
of clicking noises to check the door lock and does a quick
drain.
• There may be a pause or soak period in the cycle. Wait briefly
and the washing machine may start.
• Make sure the mesh filter of the water supply hose at the
water taps are not clogged. Periodically clean the mesh filter.
• If the washing machine is not supplied with sufficient power,
the washing machine temporarily will not drain or spin. As
soon as the washing machine regains sufficient power, it will
operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush
water lines.
• Make sure the water heater is set to supply a minimum
120 °F (49 °C) hot water at the tap. Also, check the water
heater capacity and recovery rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter
may be clogged.
• While the washing machine fills, the water temperature may
change as the automatic temperature control feature checks
incoming water temperature. This is normal.
• While the washing machine fills, you may notice just hot and/
or just cold water going through the dispenser when cold or
warm temperatures are selected.
This is a normal function of the automatic temperature
control feature as the washing machine determines the water
temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
Action
English 45
2019/12/2 15:07:29