Emptying The Filter Bag - Project Source RPV31-PS Manual

OPERATION (CONTINUED)
Fully submerge vacuum under water before turning on.
1. Immerse the vacuum in the pool/spa and turning the power ON/OFF switch to the ON position.
2. Continue lowering so that the pivoting head contacts the bottom of the pool/spa, and slowly move the
vacuum across the bottom to collect debris into the filter cage of the vacuum
3. When filter cage is full or task is complete, remove the pool vacuum from the pool/spa, lift the pool vacuum while
pointing it downwards to allow water to escape from the vacuum and pole.
4. Immediately after removing the vacuum from the pool / spa turn the power ON/OFF switch to the OFF position.
Then, you can empty the filter bag and charge the vacuum for the next use.
NOTE: Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
CAUTION
• Use only original accessories delivered with this product.
• DO NOT use this pool vacuum immediately after pool-shocking. It is recommended to leave the pool circulating for at
least 24-48 hours.
• It is not recommended to use this pool vacuum with another pool vacuum/cleaner simultaneously.
• DO NOT leave the pool vacuum in the water when it is not in use or when battery is low as water leakage may occur.
• Make sure the pool vacuum is always facing downwards when it is inserted or removed from pool. Otherwise it may
bend the pole connector and damage it during the process.
EMPTYING THE FILTER CAGE
WARNING!
Using the electric vacuum without a filter cage in place will VOID your warranty.
To maximize the cleaning efficiency of the cleaner, be sure to clean the filter cage before and after each use.
CAUTION!
If the electric vacuum is charging, disconnect the external adaptor from the power source and
detach the pool vacuum from the charger base.
1. Place the pool vacuum on a stable surface.
2. Press the locking button until the locking hole on the clear canister can swing off freely.
3. Clean out the debris and rinse the filter cage with water. If brushing is deemed necessary, use only a soft
brush to clean the cage gently and carefully.
4. Re-position the filter cage inside the main body. Make sure the filter cage is completely inserted inside
the main body.
5. Re-install the canister, by first aligning the notch of the canister with the hook on the bottom of the main
body and then swing the canister onto main body. Make sure the locking hole on the clear canister is
secured with the locking button.
7