Table of Contents
Advertisement
Available languages
Available languages
SAFETY INFORMATION (CONTINUED)
CAUTION!
-
This pool vacuum is designed for underwater use only; it is not an all-purpose vacuum cleaner. DO NOT attempt to
use it to clean anything other than your pool / spa.
-
Use only original accessories delivered with this product.
-
DO NOT use this pool vacuum right after
to leave the pool circulating for at least 24-48 hours.
-
It is not recommended to use this pool vacuum with another pool vacuum/cleaner simultaneously.
-
Avoid picking up hard, sharp objects with this product. They may damage the pool vacuum and filter.
-
Exercise caution when cleaning pool stairs.
-
Only use the charging base for its intended purpose as outlined in this manual.
-
To avoid damaging the external adaptor and the cord, do not carry the pool vacuum by the cord or pull the cord to
disconnect it from the power source and product.
-
Charge the pool vacuum indoor in a clean, dry area with good ventilation and an ambient temperature between 5˚C
(41˚F) and 30˚C (86˚F).
-
DO NOT leave the pool vacuum charging for over 10 hours.
-
If the pool vacuum will not be used for an extended period, detach it from the charging base and use a damp cloth to
clean and dry the pool vacuum and accessories. Make sure to charge the pool vacuum to about 30% to 50% of the
battery capacity before it is stored. Store in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals, and children. Never leave the pool vacuum plugged in for long-term storage. Recharge the pool vacuum
every three months.
Above warnings and cautions are not intended to incorporate all possible instances for risks and / or severe injuries.
Pool / spa owners should always exercise extra caution and common sense when utilizing the product.
GETTING STARTED
IMPORTANT NOTE: Fully charge the electric vacuum before using it for the first time.
Charging the battery
WARNING!
•
Never use the external adaptor and charging base if any damage is detected.
•
Make sure the pool vacuum and the charging base are clean and dry before set-up.
•
DO NOT handle the pool vacuum, external adaptor and charging base while it is charging with wet hands and without shoes.
•
Connect the external adaptor to the power source through a ground fault circuit interrupter (GFCI).
•
Charge the pool vacuum with the original external adaptor provided.
•
DO NOT use power extension cords.
•
Fully charge the battery before first use.
•
Charging must be done indoors, in a dry & well-ventilated area away from sunlight, children, heat, ignition sources, and
with an ambient temperature between 5˚C (41˚F) and 30˚C (86˚F).
•
Always disconnect the external adaptor from the power source when charging is complete.
•
Do not leave the pool vacuum charging for over 10 hours.
•
Immediately turn the power off and disconnect the external adaptor from the power source if you detect any of the
following conditions: offensive or unusual odor, excessive heat, deformation, cracks, leaks or smoke
1. Place the unit on a flat surface. Make sure the pool vacuum is off by turning the power ON/OFF switch to the OFF
position prior to charging.
chlorinating/shocking the pool due to high chlorine levels. It is recommended
4
Advertisement
Chapters
Table of Contents
