Table of Contents
Advertisement
SX-1 080
10. DIAL CORD STRINGING
Remove the bonnet and front panel as des¬
cribed
in
"Disassembly"
on
page 10. Loosen
screws O
€> and remove the
blind sash as
shown in Fig. 16.
1. Turn the front-end variable capacitor shaft
fully clockwise (Vanes of capacitor fully inside.)
2. Tie one end of the string to the peg on the
dial pulley.
3. Position the dial pulley so that the set screw is
at the top and tighten the screw.
4. Pass the string through the notch in the dial
pulley, wrap it 1/2 turn around the pulley and
pass it thru pulley A ^ B pulley C
dial shaft
(3 turns)
pulley D. Next, wrap the string
two turns around the pulley, along the pulley
grooves, and tie it to the spring hook.
5. Turn the dial shaft and confirm that the
movement of the dial pulley and string is
normal, and then cut off the surplus tring.
6
.
Turn the dial shaft counter clockwise (variable
capacitor vanes fully outside) and set the dial
pointer to the start point of the scale and
attach it to the string.'
Fig. 16
Remove
blind
sash
Dial pointer
Dial shaft
27
Advertisement
Table of Contents
