Download Print this page

Operating The Lawn Mower - Stihl RM 2.2 R Instruction Manual

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 18
English
► Upend the lawn mower,
► Measure the following:
– Thickness a
– Width b
– Sharpening angle c
► If the minimum thickness or minimum width is
fallen below: replace the blade,
► If the sharpening angle is not correct: sharpen
the blade,
19.2.
► If anything is unclear: consult a STIHL special‐
ist dealer.

11 Operating the Lawn Mower

11.1
Holding and Guiding the Lawn
Mower
► Hold the handlebar with both hands so the
thumbs enclose the handlebar.
11.2
Setting the Cutting Height
Four cutting heights can be set:
– 30 mm = position 1
– 50 mm = position 2
– 70 mm = position 3
– 85 mm = position 4
The cutting height is set separately at the front
and rear. The cutting height setting must be iden‐
tical at the front and rear.
Setting the rear cutting height
► Stop the engine.
The blade must not be turning.
► Place the lawn mower on a level surface.
26
15.1.
19.2.
11 Operating the Lawn Mower
► Press the rear axle downwards.
The rear axle is released and can be adjusted.
► Move the rear axle into the desired position on
the left and right.
Setting the front cutting height
► Stop the engine.
The blade must not be turning.
► Place the lawn mower on a level surface.
► Press the front axle downwards.
The front axle is released and can be adjus‐
ted.
► Move the front axle into the desired position
on the left and right.
11.3
Mulching
During mulching, the cut grass is chopped up
several times through a special air flow guidance
system in the mower blade area and then blown
back into the turf. The clippings remain on the
lawn surface where they partially decompose
and serve as a natural fertiliser. To ensure a per‐
fect, thick lawn, mulch regularly, removing one
third of the grass height.
Requirements for good mulching results:
– Frequency: at least twice a week in the spring
(main period of growth) and once a week in
the summer and autumn.
– Mow the lawn when dry if possible.
– Use well-sharpened cutting blades.
– Select a low rate of feed.
– Vary the mowing direction and ensure that the
mowing strips overlap.
– Always mow very tall grass in stages.
0478-111-9957-A

Advertisement

loading

This manual is also suitable for:

Rm 2.0 rc