Advertisement
9-1： USB Update:
1, First update to the USB into the software inside ， Then insert the TV ， Red and green LED lights
Successful software update,
9-2： PC Update:
2 .The USB ISP to connect to the PC's USB tool port, install the driver
2.1. Card upgrade, the USB ISP tools through 4pin wire, connected to the board CN18 blue port, such as
The figure below shows
2.2 Machine upgrade, the USB ISP tools through 4pin wire, connected to the VGA upgrade the board, then connect
To the machine's VGA port, as shown below
CHAPTER 8:
If update fails,piease use
FIRMWARE UPDATE
11-1
means
22
flash and other end ，
Advertisement
