Table of Contents
Advertisement
Using special salt
Always refill with special salt
immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode the
rinsing tank.
1. Open the screw-type cap of the
compartment 1J.
2. Fill the tank with water (only required
when switching on the appliance for
the first time).
3. Then add dishwasher salt (not table
salt or tablets).
The water is displaced and runs out.
As soon as the salt refill indicator h
on the fascia is lit, top up the salt.
* depending on model
Water softening system/Special salt
Using detergents with salt
replacement substances
According to the manufacturers,
detergents with salt replacement
substances can only be used up to a
specific degree of hardness (usually
21° dH, 37° fH, 26° Clarke, 3.7 mmol/
l) if no special salt is added. For
optimum cleaning and drying results, we
recommend using special salt from a
water hardness of 14° dH (25° fH,
17° Clarke, 2.5 mmol/l).
Switching off salt refill
indicator/water softening
system
S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m
If the salt refill indicator h is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
Proceed as described under
■
system" and set the value to •:‹‹.
"Adjusting the water softening
The water softening system and salt
refill indicator are now switched off.
m
Caution
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
en
D e t e r g e n t s w i t h s a l t r e p l a c e m e n t s u b s t a n c e s
11
Advertisement
Table of Contents
