Table of Contents
Advertisement
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover
on its sides. Tilt the engine cover in the direction
of the engine and lift it to remove it from the
product.
4. Install in the opposite sequence.
To replace the motion drive belt
B
A
C
D
E
F
Park the product on a level surface. Engage the
parking brake. Refer to the belt installation decal on
the bottom side of the left footrest.
1. Remove the belt.
a) Remove the mower. See
install the cutting deck on page 23 .
Note:
Be careful with the motion drive
belt and the position of the belt guides and
keepers.
b) Disconnect the clutch wire harness (A).
c) Remove the anti-rotation link (B) on the right
side of the product.
d) Remove the belt from the stationary idler (C)
and clutching idler (D).
e) Remove the belt from the centerspan idler
(E).
f) Pull the belt to the rear part of the
product. Carefully remove the belt from the
transmission input pulley and above the
cooling fan blades (F).
g) Remove the belt from the engine pulley and
around the electrical clutch (G).
h) Move the belt to the rear part of the product
and off the steering plate (H). Remove from
the product.
22
G
H
I
To remove and
2. Install the new belt from the rear part of the
product to the front, and above the steering plate
(H) and clutch brake pedal shaft (I).
a) Pull the belt to the front of the product and
install the belt around the electrical clutch and
onto engine pulley (G).
b) Pull the belt to the rear part of the product.
c) Carefully install the belt below around the
transmission cooling fan and onto the input
pulley (F). Make sure the belt is in the belt
keeper.
d) Install the belt on the centerspan idler (E).
e) Install the belt through the stationary idler (C)
and clutching idler (D).
f) Install the anti-rotation link (B) on the right
side of the product and tighten fully.
g) Connect the clutch harness (A).
h) Make sure the belt is in all pulley grooves and
in all belt guides and keepers.
i)
Install the mower. See
the cutting deck on page 23
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove
the battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with
a wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
on page 22 .
To replace the battery
The battery is installed below the seat.
WARNING:
and burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
1. Stop the product. Refer to
page 14 .
2. Open the engine cover.
To remove and install
To replace the battery
Risk of electrical shock
To stop the product on
2301 - 001 - 01.11.2023
Advertisement
Table of Contents
