GreenWorks G40BL Operator's Manual page 4

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2 OVERVIEW
Figure 1.
Speed dial
1
On/off button
2
Lock button
3
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2 INSTALL THE TUBE
Figure 2.
1. Move the tube until the lock button engages into the
slot.
2. Connect the nozzle to the tube until the latch on the
tube engages into the opening on the nozzle.
Nozzle tip
4
Nozzle
5
Blower tube
6
WARNING
WARNING
WARNING
English
You can use the nozzle to increase airflow in tight
areas.
3.3 INSTALL THE BATTERY PACK
Figure 3.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Make sure the blower tube is in position before
operation.
4.1 START THE MACHINE
Figure 1.
1. Push the on/off button in the on position.
2. Turn the speed dial forward to increase speed.
4.2 STOP THE MACHINE
Figure 1.
1. Push the on/off button in the off position.
4.3 SPEED NOZZLES
Figure 1.
The machine has a two speed high velocity nozzle tip
which sets the machine at highest speed.
1. Move the speed nozzle tip up to high speed.
2. Move the speed nozzle tip down to low speed.
4
TIP
WARNING
WARNING