Sony SPP-A250 Operating Instructions Manual page 15

Cordless telephone with answering system
Hide thumbs Also See for SPP-A250:
Table of Contents

Advertisement

Available languages

Available languages

Preparing the battery pack
The supplied battery pack must be charged before you can
use it. Allow the battery pack to charge for about 12 hours.
Clean the charge terminals with
a soft cloth about once a month;
otherwise, the battery pack
may not be fully charged.
BWN
-=
Connect the jack.
Make sure that the red cord is on the right side.
insert the battery pack into the handset.
Place the handset onto the base unit.
Notes on charging —_——_________—
¢ Make sure the CHARGE indicator on the base unit
lights when you place the handset onto the base unit.
¢ The CHARGE indicator remains on after charging is
completed.
The battery works best when
@
When to replace the battery
charged every few days. For
The battery can be recharged many, many times.
ray Uaabtatieaded ae treturn
However, if the battery only lasts for a few minutes
pene
e: to the beet ene
even after 12 hours of charging, it needs replacement.
after every call.
ae
:
Please visit your local Sony authorized dealer or
!
service center. Please use only Sony BP-T16 battery.
if the battery becomes low
A
In the stand by mode, the
@
Battery duration
TALK/BATT LOW lamp will
A fully charged battery pack in the cordless handset
flash every 3 seconds for 1
will last approximately:
minute.
:
© 6 hours in continuous talk mode
During conversation, the
¢ 330 hours (14 days) in RING ON mode
TALK/BATT LOW lamp will
¢ 1 month in BATT SAVE mode
flash every 3 seconds and
warning beeps will be heard.
The line will be disconnected
after 1 minutes.
If this happens, disconnect the
line and replace the handset
onto the base unit to charge the
battery pack.
The battery should be fully
charged for 12 hours.
Setting up |15

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Spp-a450

Table of Contents