Download Print this page

Berkeley GEMINI ZHI-DRY-2238 Manual

Hair drying accelerator

Advertisement

Quick Links

INSTALLATION OF STAND AND BASE
1.
Assemble the stand as illustrated below.
2.
Place the machine onto the stand, and adjust it to desired height.
CAUTION:
Do not touch the surface or the safety net on the circular heating
element, as tremendous heat is produced during operation
A ground wire must be connected to the wall power supply
Machine must be serviced or repaired by a certified technician or
technician from our authorized dealer. Repaired machine must be
fully inspected in order to meet safety stands before use.
In the case where the wire is damaged or aged, new 53 (RVV)
3*0.75mm2 wire must be replaced by a certified technician from
our authorized dealer.
ATTENTIONS:
Do not move the machine around when it is operating.
Do not block the cooling vent of the machine.
The machine should be turned off for 15 minutes
after it has been operating for an hour.
Please check the machine often when it is
operating.
Keep the heating plates 4"~8" away from
customer.
Height Adjustment knob
4~8"
HAIR DRYING
GEMINI
ACCELERATOR
MODEL: ZHI-DRY-2238
Thank you very much for purchasing our Hair Dryer. Please read our
user manual carefully prior to use. If the instructions are followed,
the excellent performance and operation will be clear.
CONTACT US
972-926-6488
service@aycllc.com
www.aycllc.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the GEMINI ZHI-DRY-2238 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Berkeley GEMINI ZHI-DRY-2238

  • Page 1 INSTALLATION OF STAND AND BASE Assemble the stand as illustrated below. HAIR DRYING Place the machine onto the stand, and adjust it to desired height. GEMINI ACCELERATOR MODEL: ZHI-DRY-2238 Height Adjustment knob CAUTION: Do not touch the surface or the safety net on the circular heating element, as tremendous heat is produced during operation A ground wire must be connected to the wall power supply Machine must be serviced or repaired by a certified technician or...
  • Page 2 CONTROL PANEL: OPERATING MANUAL Boot start Boot start Plug the machine into a power supply and turn the Main Power Switch on. When “00” is displayed on the time display window, it means that the machine is ready for operation. When the circular heating element is not in its initial position, it will return to its default place.