Panasonic CS-C9CKPG Operating Instructions Manual page 10

HELPFUL INFORMATION
• Auto Operation Button
• Raise the front panel and press.
• Automatic Operation
• If the remote control fails to function or has been
misplaced, press the Auto Operation button to start
the Automatic operation.
• The Automatic operation will be activated
immediately once the Auto operation button is
pressed. However, temperature cannot be adjusted
when in this mode.
• The power indicator on the indoor unit will blink until
the operation mode is selected automatically.
• To cancel this operation, press once more.
• Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound),
press the Auto Operation button for 10 seconds
continuously or longer.
A "beep", "beep" sound will be heard at the
tenth seconds.
Note : A "beep" sound will be heard at the fifth
seconds;
However please press continuously until you
heard "beep", "beep" sound.
• Repeat the above steps if you want to switch on the
Signal Receiving Sound.
• (This is for Servicing purposes only.)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
"beep" sound will be heard after five seconds
indicating the Test Run starts to operate.
_ter a power failure, the • Setting the Temperature
operation will restart automatically after 3- 4 _tr,(_ can be saved.
minutes. _e tgher or lower than the
_tornatically under the desired temperature.
prewous opera_rflow direction when r _ _ ]
power is resumed as the operation is not stopped _ Cooling Model
by the remote control I I COOling Operati°n : 2°F higher I
• .... .,oo..,,ho '
_imer setting will be _ 14r=_r P t=mn
Y,',r_l
1_
cance,led_e us me ,d reset the t_rner. I I C_er I
• _th_ h,,at__ ....... I Heating Operation : _ Lower I
with a built-in surge
pro_er, in order to further
protect your air conditioner from being damaged by • Air Filters
abnormally strong lightning actMty, you may switch _r filters every 2 weeks.