Philips 42PW9982 User Manual page 15

Balance
SOUND
Graphic Equalizer
Sound Mode
Spatial
Headphone
Dolby Pro Logic Install
Left
Rear
Test
DOLBY
Centre Volume
PRO LOGIC
Balance
INSTALL
Rear Volume
Surround Mode
Pro Logic
Dolby 3 Stereo
Hall
Off
14
Right
Centre
Rear
*
Dolby* Pro Logic Install
Adjust the volume balance level of the loudspeakers
Most channels will sound good with the volume balance between the centre,
left, right and rear loudspeakers in an equally loud position.
However, some channels may benefit from an adjustment of the level of the
respective speakers.
Which loudspeakers are active depends on the selection you have made in the
Setup menu, p. 7, or on the Surround Mode selection you make below.
Select Pro Logic in Surround Mode of the
menu.
The Dolby Pro Logic menu can also be selected directly with the white key on the
remote control.
Select Test On.
A steady noise tone is switched sequentially through the left, centre, right and
rear loudspeakers, for 2 seconds each. This enables you to adjust the volume
of the separate loudspeakers.
The loudspeakers activated light up in the on screen graphic.
Select Centre Volume, Balance or Rear Volume and alter the selected
adjustments until all loudspeakers sound equally loud from the listeners
position.
Switch Test Off again.
Surround mode
According to the broadcast sound modes, select the Dolby Surround Sound
possibilities:
Pro Logic (with Dolby Surround encoded broadcasting or video material)
In addition to the left and right front speakers, the centre and the rear
surround loudspeakers reproduce the Dolby Surround Pro Logic sounds when
the movie or channel is marked with
This mode is especially recommended for such channels or movies.
Dolby 3 Stereo (using only the 3 front loudspeakers for enhanced stereo
reproduction)
Note there is no Dolby 3 Stereo sound signal.
This mode is intended if no rear surround loudspeakers are connected
although you may wish to take advantage of the benefits of surround sound.
The Dolby Surround encoded sources are reproduced from the left, the right
and the centre loudspeakers. Surround information is now reproduced in the
left and right front loudspeakers.
Hall (without Dolby Surround broadcasting)
This mode is recommended when you wish to add surround sound to a
broadcast which is not encoded Dolby Surround or to a mono or poor stereo
broadcast. The centre loudspeaker does not produce any signal.
Off
This mode reproduces only the left and right front sound signals.
This mode is recommended if no surround sound is desired or if there is no
surround broadcasting.
You only hear a stereo sound if the broadcast which you are watching or
listening to is transmitted in stereo or digital sound.
•
Press the green menu key repeatedly to switch off the menu.
'Dolby' 'Pro Logic' and the double-D symbol
Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories Licensing Corporation.
DOLBY PRO LOGIC INSTALL
Dolby Surround.
are trademarks of Dolby