Advertisement
=SA~F' - -' E ~TY' - --' - --' - l ' " ""NS=T.,_,R
__, _ ,
U,,_,C~T~IO=N~S~-P~A~R~Tc..,B~-----------·- ENGLISH -
• The manufacturer advises the correct use of Luminaires (lighting fixtures)! Therefore always follow
these instructions to ensure correct and safe installation and functioning of the luminaire and keep it for
future
reference.
• Turn off electrical power at main fuse or circuit breaker box before commencing
installation,
maintenance or
repair.
• If in doubt, consult a qualified electrician or contact your retail outlet Ensure that you always install the
luminiare to the local electrical
code.
Certain regulations indicate that luminaires should be installed by
a qualified
electrician.
• Observe the correct color of the wiring before
installation:
white
(N),
black (L) and green or bare
copper wire
(Ground).
• Do not connect this luminaire to a non-grounded electrical
system.WARNING:
Installing this fixture in
a non-grounded electrical system could allow metal parts of the luminaire to carry electrical current if
any wires or wire connections become broken or loose. Under this
condition,
anyone coming in contact
with the luminaire is subject to electric shock which could cause injury or
death.
• Always use wire nuts/connectors rated for the correct gauge and number of wires
used. CAUTION:
Be
certain that no bare wire strands are exposed outside of the wire nuts/connections (if
applicable).
• Be careful not to damage or cut the wire insulation (covering) during
installation.
Do not permit wires
to contact any sharp
edges.
• Do not remove thermal insulation pad(s). Doing so will result in increased temperatures and possible
risk of
fire.
• Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents.Avoid liquid on all
electrical
parts.
• Always consider all the technical specifications of the luminaire.Verify the stated icons on the
identification label on the luminaire and the icons that are shown in part A of your safety instructions.
ATTENTION:
Below you will find all the explanations with numeric reference to the icons respec-
tively in front of these PART-B safety instructions. Applicable icons to your fixture are shown in
PART-A safety
instructions.
·
0 I -This luminaire should only be installed
indoors.
02- The luminaire is suitable for outdoor
usage.
03- Only suitable for dry
locations.
04- Suitable for damp
locations.
05- Suitable for wet
locations.
06- Luminaire is suitable
for
base up
mounting.
07- Luminaire is suitable
for
base down
mounting.
08- Luminaire is suitable for horizontal
mounting.
09-
The luminaire is only suitable for fixing to the
ceiling.
I 0- The luminaire is only suitable for fixing to the wall.
I I- The luminaire is suitable for fixing to the wall and to the
ceiling.
12- Always observe the minimum distance between the lamp and the surface being lit as indicated on the
icon.
13- Free air space of at least 4 inches must be kept between top of shade and bottom of
canopy.
14- Immediately replace a cracked or broken safety glass and use only manufacturer approved
parts.
15- Strip the wire as indicated in the
diagram.
16- Use heat-resistant cable for wiring the luminaire into the
mains.
17- MAX
....
W
:
only use lamps suitable for this luminaire and keep within the maximum specified wattage.
18- The fitting is not suitable for CFL
lamps.
19- The Luminaire has a ground conductor identified with green insulation or bare copper wire
..
20- The luminaire is only suitable for a lamp with built-in safety or a low pressure lamp.An extra safety
glass is not
necessary.
21- Capsule and linear halogen lamps may not be touched by bare
hands.
22- The luminaire is equipped with a fuse
.
If the luminaire is out of order after the bulb has been replaced,
the internal fuse has to be replaced. If contact with the internal wiring can be made during this opera-
tion, this should be done by a competent
electrician.
23- The luminaire can be used with a dimming circuit Consult a qualified electrician for choosing the right
type (especially important for low voltage
luminaires).
24- The Luminaire cannot be used with a dimming circuit
25- The luminaire is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer.
26- The Luminaire utilizes GU24 Base electrical components and cannot be used with
dimmers,
timers or
other control devices.
27- Luminaire with time and light setting
options.
Minimum and maximum will be shown in the icon in part A.
28- The luminaire can be placed at a maximum of 20ft height
29- To reach an optimal
working,
you have to place the luminaire on the height mentioned in the icon.The
maximum and minimum reach of the detector is also mentioned in the icon in partA.
30- The standard active range of vision of the detector covers the given degrees mentioned in the
icon.
31- Ensure that you don't drill through electrical wires or any other obstruction in the wall or ceiling
during installation!
32- This luminaire contains in some places very hot
parts.
33- This product is not suitable for children under 14
years.
The Luminaire - as well as all other products from the collection
-
is designed and tested in accordance
with the strictest national safety
standards.
In case of construction faults or material damages, the manufac-
turer gives a guarantee up to I year (unless otherwise stated on the
packaging).
Light bulbs and batteries
do not fall under the guarantee
terms.
Most ballasts, transformers, electronic drivers and emergency
battery packs are covered by separate ballast manufacturer's
warranties,
contact Philips for
exceptions.
Any
damage caused to the luminaire in extreme conditions (coastal areas, industrial surroundings, farm environ-
ments) will not be covered by the
guarantee.
The period of guarantee starts from the purchase date and is
only valid on presentation of receipt The guarantee is void if the luminaire was not installed following the
instructions or repaired or modified. The manufacturer does not accept any liability for damage caused as
a result of misuse or wrong application of the luminaire.
Alterations in design and technical specifications
reserved.
■
Advertisement
