Advertisement
VSX-4500S,-4400
(5) SPEAKERS (FRONT) terminals
A: Connect to a first set of speakers.
B: Connect to a second set of speakers.
Speaker lead wire preparation and connection.
Cutter
eS)
:
\ Speaker cable
Twist the strands.
10mm
@
Push up
Push down.
@) Insert
NOTE:
Do not allow any of the cord's conductors to protrude from the terminals
or touch any other conductors. Malfunctioning or breakdowns may
occur when conductors come into contacts with each other.
Use speakers of impedance 40 — 162. Also set the IMPEDANCE
SELECTOR switch to match the impedance of your speakers.
REMOTE CONTROL IN/OUT jacks
IN: Connect this jack to other Pioneer components (main unit or remote
control unit} when using those components to control this unit.
OUT: Connect this jack to other Pioneer components when using the
remote control of this unit to control the other components.
NOTE:
The receiver's remote sensor does not function when a plug is inserted
in the IN jack. To operate, point the remote contro/ unit at the remote
sensor on the component to which the receiver's IN jack is connected.
CONTROL
o~
Ll
(Ol
Gor
To the CONTROL
IN jack of other
component.
Receiver
Pioneer component
bearing the §jj mark.
Remote control
unit
@?) MULTI-ROOM REMOTE IN jack
Connect the adaptor (MR-100, sold separately) to this Multi-Remote
IN jack. Youcan operate the unit by remote control through the adaptor.
It is convenient when the unit is located in a separate room.
IMPEDANCE SELECTOR switch
Set this switch to match the impedance of your speakers.
position
position
o 1 Me
——I
L,
A ORB:
A ORB:
40 TO LESS
80 OR
THAN 80
MORE
A + B: 80 OR MORE
¢ When using a pair of speakers:
Impedance of a speaker
Selector position
40 to less than 80
8 or more
¢ When using two pairs of speakers:
Select
@ as the selector switch position and use speakers having
impedance of 8 ohms or more.
NOTE:
Turn off the receiver's power before changing the impedance selector
Switch setting.
Power cord
Manufactured under license from Dolby Laboratories Licensing
Corporation.
Additionally
licensed under one
or more
of the
following patents:
U.S. numbers
3,632,886,
3,746,792
and
3,959,590;
CANADA
numbers
1,004,603
and
1,037,877.
"Dolby''
and the double-D
symbol
are trademarks
of Dolby
Laboratories Licensing Corporation.
Manufacturé
sous
licence
de
Dolby
Laboratories
Licensing
Corporation. En outre, sous license d'un ou plusiers dés brevets
suivants:
numéros
américains
3,632,886,
3,746,792
et
3,959,590;
numéros canadiens
1,004,603
et 1,037,877. Le
terme ''Dolby"' et le symbole Double-D sont des marques dépostes
de Dolby Laboratories Licensing Corporation.
Advertisement
