C) Control Linkage - Reely SKY Jet Liner Manual

c) Control linkage

Install a servo arm as illustrated to the right.
Make sure that the linkage connector (1) can be rotated easily but is still installed
tight enough on the servo arm.
Our tip: To prevent the screw connection from getting loose, it is advisable to
secure it with a drop of superglue on the nut (2).
Figure 19a
Install the rudder arm (1) at a 45° angle to the servo (2). Insert the linkage rods
(3) into the linkage connectors (4).
Then shorten the linkage with an excess length of approx. 5 mm and secure
the grub screws of the linkage connectors using threadlocker.
When adjusting servo travel, make sure that the servo does not move too far
and is blocked!
Figure 19b
47