Allen + Roth VL-EO18DL Manual page 17

OPERATION
IMPORTANT: This gas log set requires curing the first time that they are put into opera-
tion. You must complete the following instructions for curing to avoid cracking the logs with
continued use.
During the 3 hour "curing period" of the appliance, you may detect an odor from the appliance. Do
not be alarmed, this is a temporary and normal situation, which indicates the various compounds and
paints being used in the log set are curing. Optionally, additional ventilation to the room during this
"curing period" may be something to consider.
Proper curing of the logs should go as follows:
1) Ignite a 2" flame. Maintain for 1 hour
2) Let the logs cool down for 30 minutes
3) Ignite the appliance again, but with the flame 2" higher than the last time. Maintain for 1 hour
4) Repeat steps 2-3 until flame reaches maximum height, and for a total of 3 hours.
LIGHTING INSTRUCTIONS - MATCH LIGHT UNITS
1. STOP! Read the safety information as noted above.
WARNING: BE SURE THAT THE CHIMNEY DAMPER IS
FULLY OPEN.
2. Read all warnings and safety information in this manual.
3. Turn keyed shutoff valve to the "OFF" position (see Figure 30).
4. Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow
the safety instructions on the previous page named "WHAT TO DO IF YOU
SMELL GAS". If you do not smell gas, continue onto the next step.
5. Place a burning match on the surface of the burner embers. Do not hold
match in hand.
6. Slowly turn keyed shutoff valve ON. The gas should ignite in five (5)
seconds. If there is no ignition within ten seconds of laying the match down,
set keyed shutoff valve to OFF and repeat steps 1-5 again.
WARNING: The fireplace screen must be in place when the appliance is operating and,
unless other provisions for combustion are provided, the screen shall have an opening(s) for
introduction of combustion air.
WARNING: Any glass doors shall be completely opened while appliance is in operation.
TO TURN OFF GAS TO APPLIANCE
1. Gently turn the keyed shutoff valve to the "OFF" position. (See Figure 30).
17
Fig. 30 - Keyed
Shut-Off Valve -
"OFF" Position