Table of Contents
Advertisement
most operations.
• To use Alexa voice control operations, you need to
pair (link) the TV with the remote control.
When you started the initial TV installation, the TV
invited you to long press the PAIR key, and by
doing so, the pairing was done.
Note:
1 - Once the remote control has entered pairing
mode successfully, the blue LED indicator ring around
the microphone on the front side of the remote
control starts blinking.
2 - The remote control must be kept close to the TV
(within 1m distance) during pairing in order to ensure
success.
3 - If the TV does not launch the Alexa voice
control operations when press
unsuccessful.
4 - It is advisable to wait until the set has fully started
up and launched all background processes before
pairing mode is entered as the toast message
containing further instructions may appear too late,
thereby negatively impacting the pairing procedure.
Pairing or pairing again
If the pairing with the remote control was lost, you
can pair the TV with the remote control again.
You can simply long press
the PAIR key (approximate for 3 seconds) for
pairing.
Alternatively, go (Home) > Settings > All settings
> Wireless and network > Remote control > Pair
remote control, then follow the on-screen
instructions.
A message appears when the pairing is successful.
Remote Control Software
(Home) > Settings > All settings > Wireless and
network > Remote control > Current software info
Once the remote control is paired, you can check the
current remote control software version.
(Home) > Settings > All settings > Wireless and
network > Remote control > Update remote
control software
Check available remote control software for updates.
3.3
IR sensor
The TV can receive commands from a remote control
that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point
the remote control at the infrared sensor on the front
of the TV.
Alexa, pairing was
Warning
Do not put any objects in front of IR sensor of the TV,
it may block the IR signal.
3.4
Joystick - Local Control
Keys on TV
If you lost the remote control or its batteries are
empty, you can still do some basic TV operations.
To open the basic menu...
1 - With the TV switched on, press the joystick key on
the bottom of the TV to bring up the basic menu.
2 - Press left or right to
select Volume, Channel or Sources.
Select Demo, to start a demo movie.
3 - Press up or down to adjust the volume or tune to
the next or previous channel. Press up or down to go
through the list of sources, including the tuner
selection.
The menu will disappear automatically.
9
Advertisement
Table of Contents
