Subscribe to Our Youtube Channel
Related Manuals for rollease acmeda CHANNEL GUIDE
Summary of Contents for rollease acmeda CHANNEL GUIDE
- Page 1 INSTALLATION MANUAL Skyline Bottom Up CHANNEL GUIDE INSTALLATION MANUAL v3.0 | September 2023...
-
Page 2: Table Of Contents
........................15 DISCLAIMER INTRODUCTION This Installation manual for Channel Guide has been produced by Rollease Acmeda to supply the necessary information for the safe and correct installation of Channel Guide. DISCLAIMER Rollease Acmeda has used reasonable care in preparing the information included in this document, but makes no representations or warranties as to the completeness or accuracy of the information. -
Page 3: Section A | Tools And Additional Items Required
Scissors • Measuring Tape PART B – ADDITIONAL ITEMS REQUIRED (NOT SUPPLIED) To install a Channel Guide the following non-stocked items are required: • Fixings for Box/Open Brackets/Hardware (ensure appropriate fixings are used to suit application) • Trims to conceal packing (if required) PART C –... -
Page 4: Section B | Installation
Where there is uneven ground, side rails may be supplied in different lengths for a better aesthetical finish to blind Page. 4 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... - Page 5 BLIND WIDTH = W1 MEASURING TIPS BLIND WIDTH = W2 BLIND WIDTH = W1 DROP (mm) 2040 2000 LEFT RIGHT BLIND WIDTH = W1 Page. 5 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
-
Page 6: Part B - Box Installation
Ensure 2 fasteners are used per side. Ensure brackets are aligned and level. Measure brackets end to end to confirm measurement is correct. Page. 6 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... -
Page 7: Part D - Blind Installation
“click” will indicate that the component is correctly located. STEP 2 – INSERT RETAINER CLIP MKII ONTO IDLER ADAPTER IDLER END Ensure pin is clipped in securely Tighten the Screw Page. 7 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... - Page 8 SECTION B | INSTALLATION STEP 3 – FEED THROUGH MOTOR CABLE (FOR MOTOR ONLY) STEP 4– RUN BLIND DOWN + CENTRE Page. 8 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
-
Page 9: Part E - Side Guide Installation
STEP 2 – LOCATE CHANNEL FIXING RAIL TO EAR FOR CORRECT POSITION NOTE: Lift out fabric & weight bar to insert fabric into side guides Page. 9 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... - Page 10 RECESS FIX NOTE: Use grooves in fixing rail to centre fixing positions NOTE: Ensure side guides are vertical and parallel using a spirit level Page. 10 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
- Page 11 STEP 5 – USE A FLAT HEAD SCREW DRIVER TO SECURE THE SIDE GUIDES TOGETHER Unlocked Position: Rotate Clockwise to Lock Locked Position: Page. 11 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
- Page 12 SECTION B | INSTALLATION STEP 6 – TEST BLIND TO ENSURE IT IS OPERATING CORRECTLY Run blind down and up to ensure correct operation Page. 12 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
-
Page 13: Part F - Weight Bar Sb07 Latch Installation
STEP 2 – SECURE LATCH TO CHANNEL COVER RAIL HD82-2366-010008 screws must be used with locks (#6 x 8mm) NOTE: Align lip of latch to Mounting Rail Page. 13 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... - Page 14 SECTION B | INSTALLATION STEP 3 – ADD ADDITIONAL LATCHES (IF REQUIRED) Page. 14 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
-
Page 15: Part G - Insert Box Cover
STEP 2 – SECURE COVER AT BOTH ENDS TOP LIMIT: Set top limit as required (should be as close to the box as possible) Page. 15 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda... - Page 16 SECTION B | INSTALLATION INSTALLED CHANNEL OPEN Page. 16 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
- Page 17 DOCUMENT CHANGE NOTES REVISION CHANGES v2.2 | August 2022 Removed 63mm spring tension chart. v3.0 | September Removed spring compatibility 2023 Page. 17 Channel Guide Installation Manual | v3.0 | September 2023 ©Copyright All Rights Reserved Rollease Acmeda...
Need help?
Do you have a question about the CHANNEL GUIDE and is the answer not in the manual?
Questions and answers