Dmx Operation; Other Features; Remote Extension; Fluid Level Detection - Ultratec G3000 Operator's Manual

DMX Operation

The G3000 is equipped with DMX control as a standard feature.
1. Attach a DMX signal to the DMX IN 5 pin connector on the rear of the unit. For good DMX practice, a terminator is
used on the DMX OUT connector.
2. Select a valid DMX address on the digital remote. Data = fog rate controlled 0-100%, DMX+1=LSG power turns on
above 50%.
3. Valid DMX LED is on solid if good DMX signal is present. DMX control overrides the digital remote. Slow or irregular
flashing indicates a poor DMX signal.

Other Features

Remote Extension

The digital remote control can be undocked from the machine and
extended by a 25' cord not supplied. This can be extended to 200'.
With the power off, press the tab located at the remote port left of the
remote control. While pressing, pull the remote out of the dock and attach
the cord.

Fluid Level Detection

The G3000 is manufactured with an Electronic Fluid Level Detection to warn
the user when the fluid has reached a low level. This information is fed to the
digital remote control where it displays "F" when the fluid level becomes low.
The machine will still run when the sensor detects low fluid. The machine can be
set to shut down on the "Low Fluid Stop" screen so it will not run dry.

Maintenance

Exterior

The casing of the G3000 is stainless steel with a powder paint coating. To clean simply wash with mild soap and warm
water.

Heat exchanger

Using high quality Ultratec fluid should result in a long heat exchanger life. (See warranty policy later in this manual).
Note: Cleaning/Rapid Change procedure can be found in the G3000 Service Manual located at:
www.ultratecfx.com
Press Tab
www.ultratecfx.com
9