Table of Contents
Advertisement
The On-Screen-Display of
the STR-D2090
The STR-D2090 has the on-screen-display function. When
ON SCREEN of this receiver is set to on, the information
concerning with the operation you will perform appears on
TV monitor screen connected to the receiver.
The on-screen-display function is available in the following
modes:
— Opening screen
— Selecting a function
— Tuner operation
— Sound field function
— Parameter adjustment of the surround effect
When the each operation is finished, the screen returns to
the opening screen.
To stop the on-screen-display function
Press ON SCREEN.
16
Adjusting Basic Audio Controls
You can enjoy superb sounds using the audio adjustment
functions as shown below.
EADPHONES -
Adjusting Volume
To adjust volume
Turn MASTER VOLUME.
To reduce the sound to a low level temporarily (— 20 dB
attenuation)
Press MUTING.
The indicator lights up.
Press again to restore the same listening level as before.
PNohtersciale Mm -re-lare Malle jal@eyeleiicem srl lle
Adjust BALANCE to correct stereo imaging, when the
speaker position is not symmetrical.
Reinforcing the Bass
.
Press DBFB (Dynamic Bass Feedback) so that the DBFB
indicator lights up. Press again to turn off the effect so that
the indicator goes off.
Selecting the Speaker System
To drive speaker system A: Set SPEAKERS to A.
To drive speaker system B: Set SPEAKERS to B.
To drive both speaker systems A and B (series connection):
Set SPEAKERS to A + B.
For headphone listening: Connect headphones to
HEADPHONES and set SPEAKERS to OFF.
IMPORTANT
Speaker systems A and B are series connected.
When only
one speaker system is connected, no sound can be heard
at the A + B position.
Advertisement
Table of Contents
