Advertisement
Device Installation/ 设备安装
A. SD Card Installation/ 安装 SD 卡
Use a 2# Phillips screwdriver to remove the bottom cover, insert the SD card.
使用 2# 十字螺丝刀将球机下盖卸下，插入 SD 卡。
CAUTION/ 注意
Do not disassemble the PTZ dome camera yourself or remove the lens protective film before the installation is
complete. Ensure that the weight bearing capacity of the pole, ceiling, wall and brackets exceeds 30 kg and the
installation environment is secure and reliable. Also, avoid magnetic interference nearby. To improve the GPS
performance, install the camera outdoors and ensure that the camera is free of obstacles above.
禁止私自拆解球机。安装完成前切勿撕下镜头保护膜。安装此设备的立杆、天花板、墙壁和支架，需确保在承重30Kg时稳定
性较好，并确保各安装环境的牢固、可靠。同时，应避免球机附近存在磁场干扰。为了确保GPS功能，须将摄像机安装在室
外，且上方无遮挡。
B. Pole-Mounted Installation/ 立杆抱装
Open up the three hose clamps and thread them through the installation holes on the pole mount.
2
将 3 个喉箍拧开，穿过抱装支架的安装孔。
B. Pole-Mounted Installation/ 立杆抱装
1
Align the screw holes on the wall mount with the screw holes on the pole mount, and use the M8 screws to
secure the bracket.
将壁装支架上的螺孔与抱装支架上相应的螺孔对齐，拧紧 M8 螺钉。
B. Pole-Mounted Installation/ 立杆抱装
Thread the cables that need to connect to the pigtail cables of the PTZ dome camera through the pole mount
3
and wall mount. Then use the hose clamps to affix the pole mount to the pole.
将需要与球机尾线对接的线缆穿过抱装支架和壁装支架。将抱箍环绕在柱杆上，拧紧抱箍，将抱装支架固定在柱杆上。
3
Advertisement
