Page 3
GLACIER DUO Ice Bath Due to our continued product improvement, product illustrated on this instruction manual may vary slightly from the actual product.
PRODUCT INTRODUCTION Water outlet Water inlet Axial fan Temperature controller MODEL (water chiller) 9000BTU Setting temperature range 0-40 C (Factory default 25 Filtration Optional 0-zone/UV Optional (30-50mg/hr) Inflow/Outflow size DN15 Inner Thread Water pump type Non-self printing Note: The specific temperature that can be reached on the usage environment.
Page 6
PRODUCT INTRODUCTION ICON NAME DESCRIPTION press once to stop cooling/ heating, and then press Run key again to turn on cooling / heating Press once to enter the target temperature setting, Set key press and hold for 6 seconds to enter the menu, and enter the correct menu password to enter the menu Up key Used to adjust parameters upward...
Page 7
PRODUCT INTRODUCTION Filteration Suggested to replace the filter every 3 months. 1. Use a wrench to unscrew the filter bottle and remove the old element. 2. Unpack the new filter element and butt it with the bottom of the bottle. 3.
Page 9
INSTALLATION AND USAGE PRECAUTIONS Installation and usage precautions 1. When connecting the water pipe between the bucket body and the chiller, please ensure that the connection is secure and check if the sealing gasket is intact (a new sealing gasket needs to be replaced after removal) 2.
INSTALLATION PRECAUTIONS WARNING • There is a built in non-self-priming water pump at the water inlet of the chiller. Ensure that the water level of outflow water from the water tank is higher than the water flow into the chiller before starting each time! Note: lt is recommended to install a leakage protector on the power supply.