Beko HCF61620X User Manual page 10

Using the appliance
3
C
You may procure lamps from
Authorised Service Agents.
1. Using a flat head screwdriver or equivalent tool,
carefully pry loose the light cover.
2. Remove the damaged light and replace with a
new one.
3. Reinstall the light cover. (it will snap shut).
4. If the lights do not work, make sure that the
lamps are fitted properly into their housings be-
fore you call for technical assistance.
Lamp
Bulb power
Holder/Socket
Bulb voltage
ILCOS Code
Size
Luminous flux
Correlated colour
temperature
This product contains a light source of energy ef-
ficiency class "E".
10 / EN
2,1 W
ZIK7
3 V
GB/T 21656-2016
D67x19,6 mm
296 lm
3500 K
3.5 Operation with flue
connection
•
Vapour is extracted through the
flue duct, which is fastened to
the connection head on the
hood.
• The diameter of the flue duct must be the same
as the connection ring. In horizontal settings, the
pipe has to have a slight upward slope (around
10º) so that the air can exit the room easily.
3.6 Operation without flue
connection
•
Air is filtered through the carbon
filter and recirculated in the
room. Carbon filter is used
when it is impossible to use a
flue in the house.
• In flueless use, remove the flaps inside the flue
adapter.
• Remove the oil filter. To install the carbon filter, fit
the filter to the tabs by centring it on the plastic
piece on both sides of the fan body. Tighten it by
turning right or left.
Replace aluminium oil filter.
•
Cooker Hood / User Manual