DeLonghi CGH1112D Manual page 5

foods at the beginning of cooking (ideal for thick meat). Press
the start/stop button, then preheat the plates by pressing
the sear buttons (10 and 17). During the preheating,the leds
around the sear button blink. Once the plate reaches the
required temperature, the appliance emits a beep, the led
stays on and fixed for one minute. Put the food on the plates
immediately; during this one minute, the appliance regulates
the plate at the sear temperature. After that, the led turns
off, the display shows the temperature set by the thermostat
dials and the appliance regulates the plate accordingly.
Please note: This function can be used once only
in every 30 minutes. After the cycle, if you press the sear
function within 30 minutes, the led around the sear button
blink 5 times and the appliance will play 3 beeps. The
operation cannot be set on the control.
WAFFLE mode (available as a separate accessory)
- Insert the waffle plates (19c/19d) as show in fig.1.
Please note that in this case the plates are not
interchangeable and the position of each plate must be
as shown in figure 8.
19c
19d
- Once the lower plate is inserted in the appliance, OFF-1-
2 or 3 appears on the display (depends on the position
of the knobs). Turn the thermostat dials to the desired
position (1= light, 2= medium, 3= dark) and press the
start/stop button.
- The appliance starts the preheating phase. When the
thermostat reaches the required temperature, the
appliance emits a beep, and is ready to use. "READY"
appears on the display.
- Lightly grease the plates with melted butter
Add one dosing cup for two waffle areas.
-
- Spread the batter slightly and close the appliance.
- Cook according to the time indicated in the recipes.
If you set the timer, three beeps will sound at the end of
the cooking cycle, the timer will disappear and "END"
will appear on the display; the appliance remains on. At
the end of the last waffle press the "start/stop" button
to switch off the appliance.
- To cook additional waffles, simply add batter to the
lower waffle plate and follow the above steps.
Important! do not use metal tools when removing
the waffle from the waffle plates as they may scratch the
non-stick surface.
Please note: This function has been optimized with
the appliance working in CLOSED position.
SANDWICH function
This function is ideal for toasting bread on the outside and
heating the inside of the sandwich. Press the SANDWICH
button (11), the function LED lights up and the default time
(05:00) appears on the display. The time can be changed
at any time simply pressing buttons - (14) + (15); the
temperature is already set, it cannot be changed because
knobs are deactivated. Press the START / STOP button and
the ON light will come on (the time on the display will start
flashing). The appliance starts the preheating phase. When
the thermostat reaches the temperature, the appliance emits
3 beep, and is ready to use. "READY" appears on the display.
Place the sandwich on the lower plate as shown in figure 9,
close with the upper one and press the SANDWICH button to
start the countdown. At the end of cooking five beeps will
sound and "--:- -" will appear on the display. At the end of
the last sandwich press START / STOP button to switch off the
appliance.
Important! do not use metal tools when removing
the sandwich as they may scratch the non-stick surface.
Please note: starting from ready situation, if you do
not press the sandwich button for the second time within
60 minutes, the appliance turn off. This function has been
optimized with the appliance working in CLOSED position.
27