Important Notes - Roland Harpsichord Cassic 50 Manual

IMPORTANT NOTES
Power Supply
Do not use the same socket that is used for any
noise generating device or large power consuming
unit.
This unit might not work properly if you plug in the
power cable with the unit turned on. If this happens,
simply turn the unit off, and turn it on again in a few
seconds.
The appropriate voltage to be used is shown on the
name plate on the rear panel. Be sure that the
voltage system in your country meets the
requirement.
Power Cord
When disconnecting the power cord from the
socket, do not pull the cord but hold the plug.
Location
Avoid operating this unit under the following
conditions.
® |n extreme heat, such as near a heater,
or where the unit is affected by direct sunlight.
© In extreme humidity.
® Where the unit is affected by dust or vibration.
Cleaning
Clean the unit with a soft cloth and a mild detergent.
Do not use solvents such as thinner or alcohol.
For C-50's User
C-50
How to attach legs:
Attach a leg to the bottom of the unit
as shown below
3 Le
Power Cord:
Put the cord through the
adjusting cramp at the
bottom of the unit, then
connect the plug to the
ea
C-50
How to open the top panel :
Lift the top
panel, and unlock
the supporting pole
to the =» direction.
Lower the top panel
so that the pole is
fixed at the hole.